Powerwalker WinPower Software V.4.3.0.1 Quick Guide Manuel d'utilisateur télécharger pdf (Page 5)

Function Explanation of “Shutdown Parameter”

1. To support the remote monitor/control function of WinPower, you need to have the similar

connection as above. It means that the Agent is connected to the UPS via RS232/USB and the other

Computers are protected via the AC Power only and all the computers are communicated under the

same Network with LAN.

2. All the computers need to install the WinPower software to keep them with the same interface for

remote shutdown application. If you don’t install the WinPower on them then you would not

able to do the remote monitor/control.

3. Owing to the fact that there is no RS232 cable connect to PC-A ~ PC-C, so you will see the

message of “no connection”. Moreover, you would find that these PC is without the in the

front of the PC listed in the WinPower monitor screen as below.

4. If all the computers are communicated within the “same section of network”, the software will

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

Powerwalker WinPower Software V.4.3.0.1 Quick Guide Manuel d'utilisateur Page 5